Looking for:
Samsung rf28hfedtsr manual |
Samsung RF28HDEDTSR Manuals - Samsung rf28hfedtsr manual
Refer to installation instructions in this manual. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors. Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want. After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator after the temperature is sufficiently cool. SAMSUNG is not legally responsible for any damage, including, but not limited to, property damage caused by water leakage from the use of a generic water filter. The Filter light turns red to let you know when it is time to change your water filter cartridge. To give you time to get a new filter, the red light comes on just before the capacity of the current filter runs out.
Changing the filter on time provides you with the freshest, cleanest water from your refrigerator. Shut off the water supply. If you are having difficulties, grip the water filter firmly and pull it hard.
This is normal. To minimize the water leaks, keep the filter cartridge horizontal when you pull it. Removing any residual matter inside the water supply line after installing the water filter. Turn ON the the water supply if you turned it off when you installed the water filter. Run water through the dispenser until the water runs clear approx.
This will clean the water supply system and remove air from the lines. Open the Refrigerator door and make sure there are no water leaks coming from the water filter. Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser. This means that there is still air in the line. If the temperature of the Freezer and Fridge compartments are too high or low, adjust the temperature manually.
Press the Freezer button repeatedly until the desired temperature is shown in the temperature display. See below. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display. The temperature control process for the Fridge works just like the Freezer process. Press the Fridge button to set your desired temperature.
After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display. Once the Freezer and Fridge temperature return to their normal set temperatures, the blinking will stop.
Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center. Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
Water may overflow or ice may jam the bucket. When the chime sounds, release the Test button. Allow your refrigerator to operate and cool down for 24 hours or 1 full day. Do not use harsh or abrasive cleaners or solvents. If a power failure occurs, ice cubes may melt, and then freeze together when the power comes back on, preventing the dispenser from working properly. To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water.
The ice maker will make new ice faster after you return the ice bucket to the refrigerator. If you use all the ice at once, you must repeat Steps 2 and 3 under Ice Making. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production.
If you leave the ice cubes in the bucket, the ice cubes may clump together, making it difficult to remove them. To remove the ice bucket safely and avoid injury, hold the bottom of the bucket with one hand and the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight out. If the ice bucket is not pushed firmly into place, ice in the bucket can melt. If the bucket does not fit, turn the helix 90 degree see the last illustration on the right, below and try again. Otherwise, odor and mold may develop.
Remove it to clean it. When you insert the Ice maker tray, be sure that the tray is well centered at the entrance. Otherwise, the tray may get stuck.
All water provided to the refrigerator flows through the core filter which is an alkaline water filter. In the filtering process, the pressure of the water that has flowed out of the filter is increased, and the water becomes saturated with oxygen and nitrogen. When this water flows out into the air, the pressure plummets and the oxygen and nitrogen get supersaturated, which results in gas bubbles.
The water may temporarily look misty or cloudy due to these oxygen bubbles. After a few seconds, the water will look clear. Please wait 1 second before removing the cup after dispensing water to prevent spills.
Do not pull out the lever dispenser after dispensing ice or water. It comes back automatically. Ice is made in cubes. Review the illustration below to become more familiar with the parts and features of your refrigerator. When closing the door, make sure the Vertical Hinged Section is in the correct position to avoid scratching the other door.
If the Vertical Hinged Section is reversed, put it back to the right position and close the door. Moisture may appear at times on the Vertical Hinged Section. The door handle may become loose over time. If this happens, tighten the bolts found on the inside of the door.
If you close one door with too much force, the other door may open. When the door opens, the interlock switch automatically turns off the auger motor in the ice maker for safety reasons.
This pantry can be used for large party trays, deli items, pizza, beverages, or miscellaneous items. There is a temperature control which can adjust the amount of cold air allowed into the pantry. The control is located on the right side of the pantry.
This feature helps keep food fresh for a long time. This feature helps keep food fresh for a longer time. This feature also helps keep meat or fish fresh for a longer time. The table below lists the Pantry modes and the kinds of foods that can be stored safely for each mode.
Fruits and vegetables may be damaged if you set the Pantry to the Chilled mode. Do not store lettuce or other leafy produce in this pantry. Do not store glass bottles in the Cool Select Pantry.
If they are freeze, they can break and cause personal injury. Ensure that the doors close all the way and are securely sealed. When the refrigerator door is only partially open, it will automatically close.
But, the door will stay open when opened more than the auto close range and you must close it manually. Tilt up the rear of the drawer and lift straight out.
Lower the drawer into place until it is horizontal and slide the drawer 3 in. Tilt up the rear of the bin and lift it out to remove. Caring for your Samsung French Door Refrigerator prolongs the life of your appliance and helps keep the refrigerator free of odor and germs. Clean the inside walls and accessories with a mild detergent and then wipe dry with a soft cloth. Just make sure to dry drawers and shelves before putting them back into place.
The doors, handles, and cabinet surfaces should be cleaned with a mild detergent and then wiped dry with a soft cloth. To keep your appliance looking its best, polish the exterior once or twice a year. Do not spray water directly on the refrigerator. Use a clean, damp cloth to clean. To prevent that residual ice from melting and running out of the chute, you should clean out the residual ice when you see it start to collect in the ice chute.
If the rubber door seals are dirty, the doors may not close properly, and the refrigerator will not operate efficiently. Keep the door seals free of dust or stains by cleaning the doors with a mild detergent and damp cloth. Wipe dry with a clean, soft cloth. Do not clean the refrigerator with benzene, thinner, or car detergent. These substances could cause a fire.
To keep cords and exposed parts free of dust and dirt accumulation, vacuum the rear side of the appliance once or twice a year. American Meat Institute Foundation. Yellow pages: answers to predictable questions consumers ask about meat and poultry. The food keeper.
Food Marketing Institute, Washington, D. Freeland-Graves, J. Foundations of food preparation, 6th ed. Prentice-Hall, Inc. Englewood Cliffs, NJ. Hillers, V. Storing foods at home. EB National Restaurant Association. Be cool-chill out! Refrigerate promptly. Basics for handling food safely. If it is, set the freezer or fridge to a colder temperature. If so, it may not be able to cool sufficiently. Install it in a location that is out of direct sunlight and not near a heat source.
Keep it an appropriate distance from the wall. To keep the refrigerator at a suitable temperature, do not fill the refrigerator with too much food. If so, raise the set temperature inside the refrigerator. Set the refrigerator warmer. Try moving those items to the other shelves in the fridge instead of keeping them in the colder areas or bins. It occurs because various parts contract or expand in response to temperature changes in the refrigerator interior.
The sound is caused by the compressor operating at high capacity. The cabinet-door sealing area of the appliance is hot and condensation is occurring. Condensation can occur when you leave the door open for a long time. If it is not properly installed, the ice making function may not work. The bubbling comes from refrigerant circulating through the refrigerator. When cleaning the inside of the fridge, store food elsewhere and unplug the appliance. Wipe with a dry dishcloth after hours and then circulate air inside the refrigerator.
Remove any obstructions so air can circulate freely. If the freezer drawer is not completely closed or is blocked, humidity from outside may enter and cause severe frost to form. Show All Parts. Refrigerator door switch Part DAC. Add to cart. Refrigerator flipper assembly Part DAA. Refrigerator freezer door handle support Part DAA.
Refrigerator roller Part DAA. Refrigerator door hinge bushing Part DAA. Refrigerator freezer door handle end cap Part DAA. Refrigerator freezer door handle Part DAC. Refrigerator ice maker assembly Part DAB. Refrigerator compressor start relay Part DAN. Refrigerator door handle mounting stud Part DAA. Show More Parts. Air Compressor. Bottom-Mount Refrigerator. Circular Saw. Ryobi Circular saw Replacement Parts.
❿
No comments:
Post a Comment